Flat Laser Cutting
We use laser cutting technologies that guarantee precision, flexibility and speed of processing.
Metal cutting: our department
Our Flat Laser cutting department is made up of 2 laser systems, a sander and some vertical warehouses and cantilevers for storing the material.
There are two different types of Flat Laser systems in our plant: one with CO2 technology and another with Fiber Laser technology. Both have a working range of 3000x1500mm and always perform a perfect cut regardless of the material and its thickness.
Moreover, the fiber system is served with an automatic nozzle change and a 10-drawer tower to ensure maximum working flexibility.
In addition to the Flat Laser Cutting machinery, our department is supported by a 4-group sanding system. This allows us to carry out surface cleaning, edge removal, breaking of sharp edges and, if needed or requested, satin finishing.
How does Laser Cutting work?
The fundamental principle of this technology is the use of a laser beam that works on the metal surfaces separating the material through the heat, and causes the metal to melt without direct contact between the cutting machinery and the surface.
This eliminates any risk of wearing of the component that is subjected to the cutting.
The cut resulting from this flat laser system is clean and precise: once made, the metal component will not need other finishing or correction, but can be passed to subsequent stages towards the finished product.
An important aspect is the management of material traceability. In fact, our manufacturing procedures require that, upon the receipt of any raw material, the latter is immediately identified and the casting of the material equipped with a barcode, which is unique to each batch.
This traceability system will be attached to each piece cut from the same metal sheet and, in case our Customer requests it, all the relevant certifications can be provided.
Advantages:
โข Quality cuts without dross
โข Clear definition of edges and corners
โข Limited thermal alteration
โข Possibility of marking pieces
